Produkter   » Märklin H0 » Elektriskt » Produkt

60965

Märklin mSD Ljuddekoder ånglok
Kampanjvara
Pris: 708 kr/st
Pris: 786 kr/st
Märklin
60965

60965 Märklin mSD Ljuddekoder ånglok

60965

Gauge: H0
 
Märklin mSD Ljuddekoder för ånglok 8-pins NEM med kabel, stödjer mfx, MM1, MM2 och DCC, förprogrammerat ljud för ånglok. 
 
This decoder is for converting Märklin/Trix H0 locomotives with built-in high-efficiency motors or other DC motors. The märklin mSD SoundDecoder has a wiring harness soldered to it. This wiring harness has an eight-pin NEM connector plug for converting many locomotives with a corresponding NEM connector and locomotives without much space. The märklin mSD SoundDecoder supports the digital formats mfx, MM 1, MM2, and DCC. The decoder has preset sound for a steam locomotive. 
 
Conversion Decoder:
Decoder with extensive sound functions and with a wiring harness
1 auxiliary function on the hardware (+2 instead of a motor also possible)
60965 for steam locomotive
60966 for diesel locomotive
60967 for electric locomotive
 
Common Features:
Can be used for all Trixand Märklin H0 Locomotives!
 
Protocols:
MM2
MFX
DCC
Analog AC
Analog DC
 
Motor:
Monitoring
Sine
As function outputs
 
Mapping using:
MFX
DCC
 
Braking Module:
Märklin
DCC
 
Speed Levels:
14 (DCC, MM2)
27 (MM2)
28 (DCC)
128 (DCC, MFX)
 
Operating Mode Outputs:
Dimmer (for dimming)
Flash 1
Flash 2
Strobe (1 light flashing)
Double Strobe (2 lights flashing)
Random
Smoke
Zoom
Mars
Gyrating Lights
Neon
Energy Save
Software for Telex
 
Analog Functions:
Acceleration and braking delay can be adjusted.
You can set which auxiliary functions are to be active.
Load compensation monitoring is active.
 
Functions:
Auxiliary outputs can have a maximum load of 250 milliamps(limited only by the total maximum load for the decoder).
Switching range control.
 
Settings:
The mLDand mSDcan be programmed with all Märklin central units (6021 to 60215). On the 6021 programming can be done up to and including CV 80 (system design).
Full programming can also be done with the current Mobile Station.
The mLDand mSDsupport all DCC programming modes including POM(main track programming).
 
Operational Safety:
A false operational bit is supported so that locomotives from an analog area can enter a digital area without going into reverse.
The fastest possible startup after an interruption in operation (thanks to memory storage of the last settings for a locomotive’s decoder). 
 
Ease of Operation:
The mLDand mSDare protected against short circuits and overloads.
The mLDand mSDcan be updated.
* Not on mSD with wiring harness
** 1 auxiliary function on mSD with wiring harness
 

Tillbaka